pentair screenlogic searching for system controller

You can also try the previous step again if it doesn’t work once when you try it, though hit the reset button on each device this time around. For a gazillion connection issues, there is this little solution which works in the majority of cases. Screenlogic can be acting up, but sometimes all it needs to work again is a simple reboot. This should reset the system in case of Dynamic addresses. Once you see the router booted, turn on the rest of the devices attached to the router. Screenlogic wireless router would power up the protocol adapter. Now switch them on again, starting with the modem (cable/DSL), wireless router, the control center and Screenlogic wireless router. Start by turning off the modem, router, control center and all the internet devices connected to the router.

Uniforming the network will solve the problem in this case. Many routers can emit more than a single signal. If you are running more than a single wireless router, this probably is why your Screenlogic is writhing with issues. Make sure that the network remains the same throughout. Here’s what to do if your Screenlogic refuses to connect locally or remotely:Ī network issue is the most common reason for a failed connection, impacting both the local and the remote connection. The sooner you find the cause, the quicker you can deal with the problem. But you can manage well if you tweak around in a set pattern. However, occasionally, you can encounter some problems, and troubleshooting may seem daunting, without the help of a professional. You can’t go wrong with this, as managing the pool becomes nearly effortless. There must be some way to reboot the PA back to default settings (the 3 resets presses clearly do not work).Screenlogic is practical, versatile and offers a reliable interface to monitor your spa. I believe this is my issue and do not want to spend $400+ unnecessarily. Without knowing the PA’s ip there is no way to see it on the network.Īfter reading for hours on TFP I see a lot of issues with PA’s losing communication when the router is changed. I contact the previous owner and they said it worked fine before they moved out. They concluded the PA needs to be replaced. I called pentair support and they had me hit the reset button 3 times and nothing. When connecting using the PC app (as admin on windows 10) the white box is blank. When I open the screen logic iOS app and try to connect it shows: Searching for system controller. When I connected everything to my home network, all the lights worked (red light on PA on and Tx/Rx lights flashing on the wireless interface and also on the antenna). The previous owner left the screen logic protocol adaptor and wireless interface. My issue is with the Screen Logic system that does not work.

I just bought a house with pentair controls.

Pentair screenlogic searching for system controller